65 lines
1.7 KiB
Plaintext
65 lines
1.7 KiB
Plaintext
* NXP SJA1105P 10/100/1000 Ethernet Switch Driver
|
|
|
|
Required properties:
|
|
### Properties of top level
|
|
- compatible: Should be "qcom,nxp,sja1105p-switch".
|
|
- reg: Should contain SPI chip select.
|
|
- spi-max-frequency: Should contain maximum spi clock frequency
|
|
for slave device.
|
|
- spi-cpha: SPI configuration to enable shift clock phase (CPHA) mode.
|
|
- switch-speed: Should contain switch ports speed 10/100/1000 Mbps.
|
|
- pinctrl-names : Names corresponding to the numbered pinctrl states
|
|
- pinctrl-<n> : Pinctrl states as described in bindings/pinctrl/pinctrl-bindings.txt
|
|
- qcom,reset-gpio: Reference to the GPIO connected to the reset input.
|
|
|
|
### Properties of the port-X child node
|
|
- `null-phy`: Determines if the port has a PHY connected to it or not
|
|
- `phy-ref`: _phandle_ to the connected ethernet PHY
|
|
**NOTE**: Must be `0x00` in case there is no PHY connected to port-X
|
|
(for example if port-X is a host port or a cascaded port)
|
|
- `logical-port-num`: logical port number, used for the port mapping
|
|
**NOTE**: Must be `0xff` in case port-X is a cascaded port.
|
|
|
|
Example:
|
|
|
|
sja1105: ethernet-switch@0{
|
|
compatible = "qcom,nxp,sja1105p-switch";
|
|
reg = <0>;
|
|
spi-max-frequency = <12000000>;
|
|
spi-cpha;
|
|
switch-speed = <1000>;
|
|
pinctrl-names = "default";
|
|
pinctrl-0 = <&sja1105_default>;
|
|
qcom,reset-gpio = <&tlmm 91 0x1>;
|
|
|
|
port-0 {
|
|
null-phy = <0x1>;
|
|
phy-ref = < 0 >;
|
|
logical-port-num = < 0 >;
|
|
};
|
|
|
|
port-1 {
|
|
null-phy = <0x1>;
|
|
phy-ref = < 0 >;
|
|
logical-port-num = < 1 >;
|
|
};
|
|
|
|
port-2 {
|
|
null-phy = <0x1>;
|
|
phy-ref = < 0 >;
|
|
logical-port-num = < 2 >;
|
|
};
|
|
|
|
port-3 {
|
|
null-phy = <0x1>;
|
|
phy-ref = < 0 >;
|
|
logical-port-num = < 3 >;
|
|
};
|
|
|
|
port-4 {
|
|
null-phy = <0x1>;
|
|
phy-ref = < 0 >;
|
|
logical-port-num = < 4 >;
|
|
};
|
|
};
|